1. Choosing the best place to fix Inspector device
    • Installer shall check a good place on a wall that is closest to: UPS cables, Mains cables and other cables
    • Make sure that place can be accessed easily for further maintenance and for the rest of installation
    • Make sure that place is not below any air conditioner because sometimes air conditioner may leak water on the device
  1. Fixing the device on the wall
    • Open the cover of the device by removing the 4 screws on the device cover


    • Remove the battery through 4 nuts and the whole holder will be removed in order to get access to the four mounting holes

Remove the jumper before the installation.


This jumper will be replaced accordingly to the type of configuration that will be installed in the following sections.


    • Fixing Inspector on the wall at the best place you picked using the mounting kit (screws and fishers) with the device


For more information, check:

Installation Drawings

Disassembly Manual