Now everything is connected right, you shall turn on the circuit breakers and turn on On/Off switch on Inspector device
You will see the 3 LEDs of the device blinking and after 10 seconds they will stabilize. The Running LED shall be turned on constantly. The Online LED shall be turned ON constantly if the device is connected to internet
Apply the configurations needed for Inspector device according to the site. For Inspector configuration, refer to Software Configurationschapter
After applying the configurations, you can check for the readings on the website and validate all measurements
Wait for 3 minutes and check the router LEDs. If they are all turned ON except WIFI LED, the device shall be sending readings to the website every 4 minutes Otherwise, recheck the cable connections and the signal at the router
