• The router has two connectors on Inspector board; one connector for power and the other for Ethernet
  • The cable of router power can be extended up to 30 meters with a cable of two wires and 0.5mm thickness of the wire
  • The Ethernet cable is CAT6 and also can be extended to 30 meters. The wire configuration of the cable is straight with standard Ethernet connection
  • The 3G signal shall be tested at the router place (panel place) using a mobile phone that has the same network operator as the USB modem attached to the router or using the USB modem attached to a laptop. If 3G signal is strong, the router will be fixed at this place
  • If the signal was weak, the router will be fixed at a different place that has stronger 3G signal


Note:

You can change the network operator (USB modem) to get a stronger signal.

You can use a pre-installed router instead of the attached router if you wish but you shall reconfigure the network configurations according to the network at the site.